![]() Since most RouterOS devices can perform either as layer 2 or layer 3, you need to choose your setup of switch chip and CPU. If you have several ports cabled on the network, then bridge the ports and add the address on the bridge. address "10.0.1.1/24", no network, and put the IP on the interface that is cabled to the network. If you need the router to be able to route/connect to internal networks, give the router an IP on each network, and it will create a dynamic route in the routing table and be able to connect. A MikroTik by default updates it's time use a MikroTik cloud, check Winbox: IP ⇢ Cloud: Update time is enabled. If you wish to setup a NTP/SNTP client to update from your own network, disable the cloud time. ![]() You will probably also want to setup the /Firewall, /Wireless and /IP DHCP server.Ī MikroTik has no time/date keeping battery, so it needs to update time+date on each boot. That is all - you are done with the simple setup to get internet access.Update software: System ⇢ Packages: Check for updates./ip firewall nat add chain=srcnat action=masquerade out-interface=ether1.If you need to supply NAT for local IPs:.address: 0.0.0.0/0 - Gateway: IP of next router) (or /ip route add gateway=1.2.3.4) Add a default gateway/route: IP ⇢ Route: Add (+) (Dst.7.9.13.1/24 - no network - choose the connected interface) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |